oiYWkBKNDASvg

I don't know about any plans, but I built some elevated beds by tkanig a piece of 5/8 treated plywood and building a stand for it out of 4 4 s. The stand has to be pretty stout, it will be holding a lot of weight. Build the frame first then set it on...

I don't know about any plans, but I built some elevated beds by tkanig a piece of 5/8 treated plywood and building a stand for it out of 4 4 s. The stand has to be pretty stout, it will be holding a lot of weight. Build the frame first then set it on the legs, It has six legs. I have a full frame around the outside with two cross pieces evenly spaced from end to end. I cut sides and ends out of another piece of plywood 16 tall and then attached them to the floor by running a 2 2 around the edge , set back far enough so that the outside of the sides and ends are even with the edge of the floor. I ran another wall across four feet from each end and stiffened that with 2 4 s. I used screws throughout that are rated for use in treated lumber.I have three of the beds that are three years old and still going great. Don't forget to drill holes in the floor for drainage.

Posted by Natalia (guest) on Mon 31 Dec 2012 09:58:32 PM PST